1. Plug in the power supply, turn on the power switch, and the power indicator light will light up immediately.
2. Adjust the thermostat to the required temperature. After the temperature reaches the set temperature, the indication on the upper part of the thermostat goes out, and you can start working.
3. Adjust the time controller to the required time.
4. Place the clothes flat on the lower ironing plate, then put the Heat Transfer Paper on it (pay attention to the front and back sides of the heat transfer paper), and press the handle down hard until it reaches the end point. Note: Do not use more than 30 kilograms of force, otherwise the handle may be deformed.
5. When the time controller indicating hot stamping is up, the buzzer will sound, and the handle will be lifted up to the original position.
Precautions:
1. Pressure: If the pressure is not enough or too high, you can adjust the pressure regulating knob on the back of the machine to increase the pressure in the clockwise direction; otherwise, reduce the pressure;
2. Time: When the hot stamping time reaches and the buzzer does not sound or sounds continuously, if it is not comfortable, it must be adjusted to the appropriate position;
3. Temperature: When the adjusted temperature is reached, the thermostat pointer points to the "180°C" position (reached in about 5 minutes). If the thermometer rises when the power is turned on but the heating plate does not heat, please check the circuit.
4. When the handle is pressed all the way down and your hand is released, the handle will automatically rise back up. Please adjust the adjustment knob downward.

5. When the hot stamping is completed and it feels difficult to lift the handle upwards, you can adjust the adjustment knob downwards.